With C series codecs, these cameras will work as third party cameras.
5Ħ Introduction software version TC7 Camera firmware PrecisionHD 1080p4x S2 and PrecisionHD 1080p2.5x cameras are only supported with the SX20. If a downgrade attempt fails, it may be due to lack of endpoint support or lack of Touch 8 support in the old software. For a detailed list of compatibility levels and software constraints for the Cisco TelePresence systems, please see the appendices in this document: Cisco TelePresence Systems hardware dependencies Cisco TelePresence Touch 8 hardware dependencies A lock on endpoints and Touch 8 devices prevents the system from downgrading to unsupported versions. Executing the API command xstatus SystemUnit Hardware Module CompatibilityLevel will reveal if there are any constraints on the system. This is due to end-of-life of some components and introduction of new components that require changes in the software. Due to replacement of hardware components, there are some constraints on running older software on newly manufactured endpoints and Touch 8 devices. Hardware compatibility This section is only relevant when using older software. Extended BFCP port range and Active Control ports From TC7.0, BFCP and Active Control port will dynamically use ports from the RTP port range instead of and, which was previously used. Cisco recommends TelePresence customers to migrate from H323 to SIP. When CUCM provisioning is active, H323 mode is disabled. Important notes and warnings for this software version Provisioning support When using CUCM provisioning, the endpoint cannot register to a VCS (SIP or H323) at the same time.
TC7.0.0 is only released for MX300 G2 in production and will not be released on TC7.0.1 supports all endpoints supporting TC software.
6 Camera firmware TC7.0.1 & TC New features and functionality in TC New feature descriptions TC New features and functionality in TC New feature descriptions TC Support for MX300 G2 including Touch New GUI for MX300 G Support TMS phone book when provisioned by CUCM Serviceability: Ethernet statistics on Touch IPv6 and dual stack support New diagnostic checks Changes to the syslog feature Presentation will stop when presentation source is disconnected Password protection of the Touch administrator menu Open and resolved caveats in TC Using the Bug Search Tool Resolved caveats in TC Resolved caveats in TC Open caveats in TC Open caveats in TCģ Contents Known limitations.18 Cisco Interoperability.23 H.323 gatekeepers/traversal servers SIP registrars/proxies Gateway interoperability MCU interoperability Streaming servers Endpoint Interoperability xapi Changes.30 Cisco TelePresence systems hardware dependencies.31 Introduction NAND Flash Integrated camera Using the xapi / tshell to identify software limitations Using the TAN Number to identify software limitations EX series and MX series C series and Quickset Series Cisco TelePresence Touch 8 hardware dependencies.38 New hardware revisions for Cisco TelePresence Touch Cisco TelePresence Touch 10 hardware dependencies.40 References and related documents.41 Software filenamesĤ Document revision history Document revision history Revision Date Description 02 December 17 th 2013 Release of TC7.0.1, Release for all TC endpoints 01 November 25 th 2013 Release of TC7.0.0, MX300 G2 only release 4ĥ Introduction software version TC7 Introduction software version TC7 This release note describes the features and capabilities included in the Cisco TelePresence System C/MX/EX/SX/Profile series codec software version TC7. 5 Extended BFCP port range and Active Control ports. 4 Introduction software version TC Important notes and warnings for this software version. 1 Cisco TelePresence System C/SX/EX/MX/Profile Series Software release notes TC7 D December 2013Ģ Contents Contents Contents.